How to Install a New Roof Step by Step
Whether you’re building a new home or replacing an old roof, there are some common steps you can follow to install a new roof. Using these steps will ensure that your job is done quickly and efficiently.
Removing the old roof
Getting your old roof off your home is a big job. Before you can start the replacement process, you need to remove the rotten stuff. And, you’ll need a good crew to handle it. You may need to get a building permit.
The best way to go about this task is to hire a Roofing North Vancouver contractor. They will be able to get the job done faster and with less hassle. They will provide a dumpster to haul away the leftovers. And, they’ll clean up the area a little better.
The best way to figure out which roofing materials to reuse is to take note of the color of the roof and the condition of the decking. If the decking is sagging and rotten, it might be time for a new one.
Applying adhesive to the underside of the membrane
Whenever installing a new roof, it is important to ensure that the underside of the membrane is adhered. This helps prevent blistering. It also reduces the amount of work required.
To install a new roof with a peel and stick membrane, start by cutting the underlayment to the desired length. Typically, the underlayment should be at least four inches longer than the peak of the roof. It is recommended that the underlayment have two layers of insulation. The membrane should be laid with the paper backing side against the roof. It is also recommended that the underlayment have a plastic backing.
If the underlayment is not adhering to the membrane, use a split release sheet. It may be a plastic, paper, or vinyl product. Then, use a straight edge to cut through the membrane.
Inspecting the deck surface
Performing a thorough inspection of the deck surface before installing a new roof is an important task. This will help you to identify any defects in the deck and avoid a costly replacement. However, there are many different steps to follow, and some will be more applicable to one type of deck over another.
The first step is to note the height of the posts, and the width of the tread on your stairs. This is a good indicator of how much weight the deck can support.
A deck with an uneven height may be more susceptible to deflection and may require major repair work. In fact, a deck with a height difference of 19 mm (3/4 in) or more should be coated with a fresh layer of concrete.
Applying a ridge cap
Adding a ridge cap to your roof is an important addition that keeps your roof sound and helps prevent wind damage. There are several types of ridge caps available and each has special installation instructions.
Metal ridge caps are a common choice for metal roofs. They are designed to fit the ridge and are typically installed at least 6 inches over the first piece. They are available in vented or solid styles. The vented closure lets hot air escape while the solid closure is watertight.
To prepare the ridge for a metal ridge cap, you will need to cut the ridge cap to fit the ridge. To do this, measure the length of your ridge and add 10 percent for waste.
To measure the length of your ridge, use a speed square and align it with the pitch of your roof. You can also use a protractor to measure.
Cleaning up the mess
Putting up your new roof is no fun, so cleaning it up is a top priority. The feng shui is a must, otherwise you’ll get a nice thrashing. One of the most important tasks is deciding which type of roofing materials to use on which floors of the house. This is where the es of es comes into play. The best suited occupant of the household is a happy and oh happy. Getting the new shingles on time is no small feat. Keeping your new shingles in good condition is another matter entirely. Taking care of the job is not a task for too long.
